ADV

Spirax-Monnier Automatic Drain Valve

Description

The Spirax-Monnier ADV automatic drain valve has been designed to remove condensate from any low points in a compressed air system where automatic drainage should be provided.
Condensate is a mixture of water, oil and dirt, with the thickness or viscosity increasing with low temperatures.

Principal features

– Variable discharge frequency.
– Variable discharge time.
– Low power comsumption.
– LED showing operational status.
– Reliable, long life, solid state timers.
– Manual test facilities.
– Minimal maintenance.
– Simple installation.

Applications

The Spirax-Monnier ADV automatic drain valve can be installed at any low point in a compressed air system where condensate forms or is collected.
These include after coolers, separators, receivers, large filter units and drain legs, etc.
Typical installations are shown on below.

Typical installations

ADV Spirax Monnier Automatic Drain Valve

ADV Spirax-Monnier Automatic Drain Valve.jpg

Sizes and pipe connections

¼”, 2″ and ½” screwed BSP.

Optional extras

– Solenoid valve.
– DIN connector.

Technical Data

Operating temperature range	Ambient temperature		-10 °C > +50 °C
	Media temperature		-10 °C > +130 °C
Mains voltage/pressure	230 Vac	50 Hz	16 bar
	110 Vac	50 Hz	16 bar
	120 Vac	60 Hz	16 bar
Discharge time variable	0.5 to 10 seconds
Discharge frequency variable	0.5 to 45 minutes
Connector	DIN 43650 – ISO 4400/6952
Insulation	Class F (155 °C)
Enclosure	IP65